MIGHTYLAM 2700HC Instruções de Operação descarregar pdf (Página 16)

TROUBLE SHOOTING

The following guide will assist you with most problems that may be encountered when

laminating.

PROBLEM: Laminator is inoperative. Motor does not run, indicator lights

are out.

ACTION: Unit may be unplugged. Connect power supply.

Ensure that your circuit breaker has not tripped.

Fuse may have blown. Replace fuse (back next to power cord) with 15amp

BUSS (MDA-15).

PROBLEM: Laminating film and item being laminated move through lamina-

tor erratically.

ACTION: Check thickness of item to be laminated. Maximum thickness is 1/16”

(1.6mm) if rollers have not been adjusted.

Clean heat shoes of residual adhesive. Refer to MAINTENANCE section

for cleaning instructions.

PROBLEM: Plastic is not bonding to the item or to itself at the edges.

ACTION: Make sure heat shoes and rollers are at proper operating temperature and

have had time to warm up. See table 1 for the suggested temperature

ranges.

PROBLEM: Wrinkles appear on the laminated items running parallel with the out-

side edges.

ACTION: Increase roller tension on top and/or bottom supply rolls.

Reduce heat shoe temperature.

Clean heat shoes of residual adhesive. See MAINTENANCE section for

cleaning instructions.

800-658-8788 www.abcoffice.com

abcoffice

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 25 26

Sem comentários

MIGHTYLAM 2700HC Instruções de Operação Página 16